Filament FAULT sensor - REMIX - Tangle and/or Runout
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a REMIX and enhancement to the Filament FAULT detector by re-NABLE. re-NABLE's design is good, but I had a…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 400
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a REMIX and enhancement to the Filament FAULT detector by re-NABLE.
re-NABLE's design is good, but I had a couple minor issues:
I wanted to integrate it into a heated dry box: https://www.thingiverse.com/thing:2778707 The re-NABLE "bracket" did not work with the spool holders I already printed.
I noticed binding of the filament though the lever. Adding a length of PTFE tubing reduced friction
I wanted to use a stock of my existing roller micro switches and they did not fit into the re-NABLE box.
There wasn't a sufficient "parts list" or documentation in the re-NABLE build.
Something I noticed while remodeling items was when using a roller switch, the sensor acted only as a "Tangle Sensor". Since I have a filament run-out sensor near my Bowden extruder I was fine with this.
FULL documentation is now in the Thing Files!
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.1mm to 0.2mm
Infill:
70%
Filament:
3D Solutech PLA
Notes:
70% infill should be used on the Box and Lever part.
35% infill should be suitable enough for the Bracket parts.
The two brackets that need supports - go with:
- Support Placement: Everywhere
- Support Pattern: Zig Zag
- Support Z Distance: 0.2mm
- Enable Support Interface
- Support Interface Thickness: 1.5mm
- Support Interface Resolution: 0.2mm
- Support Interface Density: 50%
- Support Interface Pattern: Lines
Category: 3D Printer Accessories