Tiny Pliers (Print-in-Place)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tiny but handy pliers.
- Ocena
- 4,89 / 5
- Polubienia
- 550
- Pobrania
- 2153
- Wydruki
- 88
- Wyświetlenia
- 6581
- Oceny
- 73
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
These tiny pliers print in place without supports in about 45 minutes. They've got notched jaws for grabbing nuts or circular items, and have a built-in opening spring for easy manipulation.
They have a 0.4mm gap around the pivot pin, so make sure your printer is calibrated to handle relatively small gaps. There is also a horizontal gap of 0.2mm between the jaws that should provide just enough separation to allow the two jaws to break free easily after printing. Therefore, make sure you use a 0.2mm layer thickness to maintain this gap.
After printing, give them a good squeeze. If your printer is well calibrated, they will break free. If not, they will just break. Good luck!
Update (5/20/22) to v02:
Spruced up a few things: added gription nubs to the handles, re-angled the jaw notches to better grab hex nuts, and added some tiny serrations to the jaw tips.