Ender dial indicator mount (rear facing)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a quick design to mount my dial indicator to the back of the Ender's X carriage. Rear mounting because I run a…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 170
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
a quick design to mount my dial indicator to the back of the Ender's X carriage.
Rear mounting because I run a bullseye and BLtouch in front which makes mounting an issue.
I wanted something that was easy on and off. so it's using an old hard drive magnet to hold it to the screws on the V slot wheels.
the "button" helps to level the gauge as the HD magnet pulls it out of alignment.
This was custom fit for my printer and gauge (and the magnet I had laying around) but it should fit a gauge with an 8mm stem and any carriage with the wheel span of 42.5mm.
screws are #4 x1.5in pan head as are the nut catches
If anyone shows interest I can adjust it to fit different magnets
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
doesn't matter
Filament:
n/a pla
Notes:
Print as imported
no supports needed
(some of the items are small if you get a pop up asking to change scale click NO)
Category: 3D Printer Accessories