UFO Abduction Lamp with blinking lights
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Version 2 of the lamp:https://cults3d.com/en/3d-model/home/ufo-lamp-oneidmonstr For this Version you need: glas…
- Ocena
- 0 / 5
- Polubienia
- 147
- Pobrania
- 312
- Wydruki
- 1
- Wyświetlenia
- 2873
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Version 2 of the lamp: https://cults3d.com/en/3d-model/home/ufo-lamp-oneidmonstr
For this Version you need:
glas cylinder with both ends open about 80mm in width
27x blue LEDs
3x white LEDs
30x 200 ohm resistors
4x 2k ohm resistors
4x 2N2222 transistor
ARDUINO nano
5M ohm potentiometer
7V power supply
green fabric
Use transparent filament on the file LED_cap_trans.stl.
Inspired by the countless abduction lamps on the internet. Especially Lasse Klein (If he was the original inventor of this great lamp design! :) )
Print Settings
Printer Brand:
Anycubic
Printer:
Kossel
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
10%
Post-Printing
Arduino Code
int A = 12;
int B = 10;
int C = 8;
int D = 6;
const int poti = 0;
void setup()
{
pinMode(A, OUTPUT);
pinMode(B, OUTPUT);
pinMode(C, OUTPUT);
pinMode(D, OUTPUT);
}
void loop()
{
int tDelay = 575;
int analogIn;
analogIn = analogRead(poti);
Serial.println(analogIn);
//************ all on************
if(analogIn < 200){
tDelay = 50;
delay(tDelay);
digitalWrite(A, HIGH); digitalWrite(B, HIGH); digitalWrite(C, HIGH); digitalWrite(D, HIGH); } else if (analogIn < 800){
//*********** rotate************
tDelay = analogIn - 150;
digitalWrite(A, HIGH);
delay(tDelay);
digitalWrite(A, LOW);
digitalWrite(B, HIGH);
delay(tDelay);
digitalWrite(B, LOW);
digitalWrite(C, HIGH);
delay(tDelay);
digitalWrite(C, LOW);
digitalWrite(D, HIGH);
delay(tDelay);
digitalWrite(D, LOW);
} else {
//***********blink*********
tDelay = analogIn - 400;
digitalWrite(A, HIGH);
digitalWrite(B, LOW);
digitalWrite(C, HIGH);
digitalWrite(D, LOW);
delay(tDelay);
digitalWrite(A, LOW);
digitalWrite(B, HIGH);
digitalWrite(C, LOW);
digitalWrite(D, HIGH);
delay(tDelay);
}
}
Category: Decor