Wire2Hotend
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bringing 20 hotend cables to one 20 pin cable.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
As I'm modding my Ender, one thing that frustrates me is having to flip the printer over just to get at the wires. And, you end up with wires that are just that little bit too short. Well, I got tired of it, and decided to take matters into my own hands.
The result of this is the Wire2Hotend. Instead of having many cables going to the hotend, you just have one cable, powered by 2 Micro Fit 3.0 connectors. You no longer need long cables, cable length no longer matters!
If you use V1.1, please note that V1.1 does NOT support older versions due to a change in trace paths.
UPDATE 2/14/23: New mounts! These mounts now remove the issue of the solder joints hitting the mount and now it uses heat set inserts! The inserts are voron spec, so you can buy from anywhere that sells voron parts. This is preparing for a new version, so stay tuned ;).
Supports:
1 Heater
1 Thermistor
1 Hotend Fan
2 Part cooling fans
1 BLTouch
1 Extruder motor
More info can be found here: https://github.com/BoredFishRE/Wire2Hotend
PCB files can be found at the GitHub listed above. Gerber files are there too.
Order on OSHPark! https://oshpark.com/shared_projects/FF4gIcaM
PLEASE NOTE: This project is provided AS IS, and is in active development. This may not work, please make at your own risk. It should work though, nothing is guaranteed.