Raspberry Pi 3/4 DIN Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on the ingenious design by jwags55. This remix is designed to fit more modern Raspberry Pi's (3 and later). The…
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 157
- Wydruki
- 1
- Wyświetlenia
- 928
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Based on the ingenious design by jwags55. This remix is designed to fit more modern Raspberry Pi's (3 and later). The tolerances were tightened up so it should be a tight fit on 35mm DIN Rails and hold the board securely. Also this mounts the boards slightly closer to the rails.Note: It's really easy for me to tune the parameters so if it's too loose/tight let me know in the comments and I can make some adjustments.
Features
- Snap fits to DIN and Board (No screws needed)
- Works with PLA
- Low profile
- No tools required
- Easy and fast to print (No supports)
Printing Tips
- Use 4 perimeters
- 4 Top/Bottom layers
- 20% Gyroid infill
- 20% Gyroid infill
Print Settings
Printer:
BLV Cube
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:
Radio Shack :-) PLA
Blue
Notes:
I always printed these in PLA. PETG would probably be more durable and longer lasting.
Category: Electronics