Spray Bottle Wall Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
https://www.printables.com/model/242706-spray-bottle-hanger-improved-for-strength
- Ocena
- 4,882 / 5
- Polubienia
- 199
- Pobrania
- 1323
- Wydruki
- 25
- Wyświetlenia
- 5429
- Oceny
- 17
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A very simple, but effective spray bottle holder that has since been improved for strength at the following link.
https://www.printables.com/model/242706-spray-bottle-hanger-improved-for-strength
No supports needed, just print, mount, done. (Mount with standard drywall screws, or whatever you have. Mount holes are 4.5mm diam, with an 80° taper, to 9mm head diameter.)
Took about 3 hr to print on an Ender 3.
I've included the Fusion 360 file in case you'd like to make some tweaks. Width is parametric in case you have a wider squeeze lever. I also included a STEP file for those with other CAD software.
EDIT: Added an "extra wide" version that's 36mm edge to edge vs the original 26mm shown in the pictures.
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm layers (0.4mm nozzle)
Infill:
Any
Filament: Any PLA or PLA+ Any
Notes:
Up your wall count so the thin sections (sides/back) are solid as it's stronger and will likely be a faster print than using infill. Still ok to have infill on the beam that is horizontal.
I used a brim to ensure it remained firmly attached to the build plate and just cut it away with a debur tool. Not required, just a helpful tool to ensure first time success.
Category: Household Supplies