Snowball Maker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I tried printing a bunch of snowball maker ideas and finally decided to just make my own. The issues I had with others…
- Ocena
- 4,875 / 5
- Polubienia
- 64
- Pobrania
- 639
- Wydruki
- 9
- Wyświetlenia
- 2067
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
I tried printing a bunch of snowball maker ideas and finally decided to just make my own. The issues I had with others were they either would break easily, required too much support to print, required gluing/assembly, were hard to use/line up, or they were not the right size (too small or too big). This snowball maker tries to avoid all those pitfalls.
No supports required.
Two unique halves to print: No assembly required unless you care to tie them together with ~3 ft of paracord/rope
.
- Easy to use as there's a guide built in to align and scoop additional snow for packing, as well as "teeth" to allow excess snow to fall away by rotating the two halves while compressing.
Print Settings
No Supports
Brim suggested
30-50% infill
3 Walls would increase durability
Post Print
Add some oil to the interface between the two halves to ensure smooth operation and avoid binding.
Clean up the brim if you used it.
Tie them together with ~3 feet of paracord if you want to avoid loosing one.
This should make a lot of snowballs in short time. Would love feedback on how it works and ways to improve.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.2mm layers (0.4mm nozzle)
Infill:
30-50%
Filament: Any PLA or PLA+ Bright (So you can see under some snow)
Category: Toys & Games