Chain System for Sapphire Plus

For base Chain to mount

1. Base top left from front view (Top_Cable_Chain_Mount.stl) I used a 10x15mm Cable chain. You can most likely use another. I drilled the holes to match my chain.
2. From top to bottom. Use Either Cable wire holder large.stl or Cable wire holder small.stl. Depending on the look you want. The large one matches the Top mount.

For Bed Chain 10x15mm

1. Mount Z-chain_bracket_for_10x15mm_Chain.stl to bed. You will have to drill 3 holes to use this. All 3 are abled to be drilled without removing the bed.
2. Insert Bed_Chain_10x15.stl from the top an slide down. This was designed for a 7x7mm chain but the 10x15mm chain fits around the outside. You have to put 2 screws with nuts to hold it. I am going to design a better on in the future.

Supports needed for Bed_Chain_10x15.stl and Top_Cable_Chain_Mount.stl

All parts are oriented how they should be printed

These are not of my design. I would like to give credit to original creators.

Bed_Chain_10x15 modified from MLoewe's TwoTrees Sapphire Pro Drag Chain Mounts https://www.thingiverse.com/thing:4042150

Top_Cable_Chain_Mount modified from magichappens Sapphire Plus Cable Chain Mount https://www.thingiverse.com/thing:4736894

Print Settings

Printer:

Two Trees Sapphire Plus (SP-5)

Rafts: 

No

Supports:

Yes

Resolution: 

0.2mm

Infill:

40%

Filament:

Esun PETG

Any

Category: 3D Printer Parts