JDO Apple Watch Stand (series 1-8 / ultra) plastic and metal charger compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Update 2021 11 December included a design for the metal charger original design is for the plastic charger added a…
- Ocena
- 4,7 / 5
- Polubienia
- 72
- Pobrania
- 797
- Wydruki
- 14
- Wyświetlenia
- 3127
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Update 2021 11 December
- included a design for the metal charger
- original design is for the plastic charger
- added a hole to easily remove the charger. Also included a paperclip pocket below the lid to keep the paperclip at hand when the need arrives to remove the holder.
Update 2019 23 October
Added a logoless version of the stand.
I've printed out some of the other amazing stands on thingiverse but none of them were perfectly suited for the new Apple Watch series 4/5 (44mm). Therefore I decided to design my own stand and behold the result here.
The stand has a lid on the bottom. This serves two purposes:
- it hides the cable in the stand
- it hides the lower quality print caused by the support structure to print this thing.
Note: to release the charger once pushed in the stand, simply take a wooden skewer and stick it up through the bottom behind the charger and push it out.
Note2: Don't slide the lid in fully at once, slide it in 10% and pull it out, then 20% and pull it out, etc. This smoothens the support surface and allows the lid to slide in and out easily.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
30%
Filament: REAL PLA Gray
Notes:
Printed with supports for the lid part of the body. The support connection surface will be concealed by the lid.
Category: Gadgets