JDO Wallet - Minimalist Wallet / Card Holder (7 cards)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hereby I announce my version of the minimalist wallet: JDO wallet. For my purposes I've designed a wallet which holds…
- Ocena
- 5 / 5
- Polubienia
- 59
- Pobrania
- 285
- Wydruki
- 1
- Wyświetlenia
- 3068
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Hereby I announce my version of the minimalist wallet: JDO wallet.
For my purposes I've designed a wallet which holds 7 cards. The cards are kept in place by the 'pressure locks' on the sides which should be printed with a flexible filament.
The lever works very well but dependent of the filament used for the 'pressure locks' the wallet should be operated with two hands.
This is iteration 8 of this design and version 2 of a physical model. The first model was printed on a different 3D printer and the layer adhesion was not that great, but it hold for about 6 months. The version shown in the images is being carried in my back pocket everyday for the last 6 months and is holding up just fine!
Use M2 screws to screw the top and bottom parts into the inset part.
I hope you enjoy the wallet as much as I have and will do.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100%
Filament: REAL PLA grey and nuclear green
Notes:
I would recommend to print all of the holder parts at 100% infill
The 'pressure locks' should be printed in flexible filament at a low infill. Please experiment with your filament and printer to get the correct part.Use M2 screws to assemble all the pieces.
Category: Organization