Drawer Pull for IKEA BRIMNES bed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These replacement drawer pulls are smoothly contoured so they won't hurt me.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 517
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Share Alike
I kept bruising my shins on the sharp wooden drawer pulls of the drawers of my IKEA BRIMNES bed.
These replacement drawer pulls are smoothly contoured so they won't hurt me.
Lightly edited from https://www.thingiverse.com/thing:3911914
My OpenSCAD modifications have it default to the correct size, with pilot holes for the two wood screws that hold the drawer pull in place.
I've attached the Prusa Slicer file I used.
https://www.thingiverse.com/thing:5395232 from https://www.thingiverse.com/thing:3911914
Notes:
Prints screw-hole side down, with supports.
Remember to use support blockers for the screw holes.
Post-Printing
These attach with wood screws slightly thinner and shorter than the original: 1" long, about a sixteenth in diameter with a #8 washer