ZMR250 side cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created a side cover for the ZMR250. It was a tight fit, but works well! There is a small gap between the side cover…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
I created a side cover for the ZMR250. It was a tight fit, but works well! There is a small gap between the side cover and the top frame near the FPV camera because of the piece holding the camera. Not much I can do about it. This won't fit if you have a Naze32 with pin headers sticking out the side. Solder the servolead for the receiver directly to the board.
If anyone wants pattens or whatever, leave a coment so I can add them. Source is from Inventor 2015 (student edition).
Print upside down (flip z-axis)!
Have fun!
Category: Vehicles