1 / 2
Adapter from 1/4" male to M14 male for a plasma cutter — zdjęcie 1
1 / 2

Adapter from 1/4" male to M14 male for a plasma cutter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple adapter I made to connect my plasma cutting torch to an air compressor. Use Teflon tape on the 1/4" end to…

Ocena
0 / 5
Polubienia
4
Pobrania
18
Wydruki
0
Wyświetlenia
210
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

A simple adapter I made to connect my plasma cutting torch to an air compressor. Use Teflon tape on the 1/4" end to screw in the rest of the armature, the hemispherical end was well sealed without any gaskets with a PET-print.

Print Settings

Printer:

Craftbot

Rafts:

No

Supports:

No

Resolution:

0.1 mm

Infill:

25 %


Notes:

Use thick walls and 10 top/bottom layers. Print slowly for precision, I used 20 mm/s. I would suggest you use PET, it is a good material for this kind of thing, because it is not brittle, but Nylon, PC, ABS or PLA (listen in order of suitability, PLA can be brittle) should work too.

Category: DIY

Tagi