Shapeoko2 penholder (pen holder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modified version of nischi's Shapeoko pen holder, with mounting holes to fit the Shapeoko 2. Also, I…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a modified version of nischi's Shapeoko pen holder, with mounting holes to fit the Shapeoko 2. Also, I modified the pen holder a bit to make it fit a standard Sharpie that is about 12mm in diameter.
Lastly, I added a couple of tabs at the bottom in case someone wants to attach a rubber band and give some downward pressure on the pen.
You can see nischi's original version here: http://www.thingiverse.com/thing:47696
Instructions
Printed on a Makerbot Replicator 2 using standard settings. An M3 screw is used to tighten around the sharpie if desired. M5 screws can be used in the slotted holes to attach to the Shapeoko 2 tool mount.
Category: Electronics