Wall Mounted Baby Wipe Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Being a new dad (and a nerd), and needing a convenient way to access baby wipes I elected to design a wall mount so…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 733
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
Being a new dad (and a nerd), and needing a convenient way to access baby wipes I elected to design a wall mount so that I could grab them as needed off the wall. There is a plate in this model that is optional, I elected to include the plate with 5 springs (relatively stiff) which I glued in so that the plate would compress the pack of wipes as it emptied.
In order to refill the holder, you depress the plate, and slide out the top piece, reverse that order of operations to reinsert.
If you print it, I hope you like it!
Print instructions
This print is fine to be printed in PLA/PETG/ABS, pretty much anything.
I had good luck with PLA using 0.2 mm layers, and 20% fill. Seems reasonable durable.
Other bits you will need include some method to mount this to a wall (will vary on your circumstances), springs (I don't have any exact recommendations as I just used some I had lying around), and some M3 hardware to hold it all together.