Car Cup Holder Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Insert for Car Cup Holder to keep short cups from dropping down too far.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 1130
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Insert that drops into your car cup holder so that the small cups of Coffee from the gas stations don't drop so low you can get them back out. Originally designed to fit in the Toyota RAV 4 but should fit in most vehicles. Recesses in the top allow it to be easily removed without having to turn your car up-side-down. They also double as convenient coin storage.
Bottom Diameter is 68 mm and the Top Diameter is 72 mm. Overall height is 25 mm. Should be able to scale it in your slicer software to get the fit you need. Depending on the degree of scaling it might result in coins not fitting in the center.
Was printed with 0.2mm layer height and 15% infill. Recommend using any Filament except PLA because of the temperatures that can be reached in a car sitting in the sun.