Line Locator's Holsters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my entire into the r/3dprinting's re:3d design contest. I have designed a pair of tool holsters that will make…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my entire into the r/3dprinting's re:3d design contest. I have designed a pair of tool holsters that will make one of my job duties much easier. Ever so often I am required to do utility Line Locates for the municipality I work for. To allow me to carry all the stuff I may need while marking our utilities, I have designed one holster to hold a can of inverted spray paint and another holster that can hold 28 wire flags and the tool I used to install them, a flat ended screwdriver.
Both are printed in Ninjaflex and these should be printed in flexible filament as them being made out of rigaid will mean they will not work.
SAFETY NOTE: Cans of spray paint can be heavy and if you over or unevenly load yourself or your belt you could injure yourself. Take care when using these holsters. These are made available as-is and I take no responsibility if you injure yourself while using these holsters.
Category: Tool Holders & Boxes