Oculus Meta Quest 2 elite strap replacements
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print your own replacements for super brittle original ones.
- Ocena
- 5 / 5
- Polubienia
- 80
- Pobrania
- 379
- Wydruki
- 2
- Wyświetlenia
- 3729
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial
Print replacement straps for your Oculus elite (with or without battery) strap.
There are three versions included:
- One piece original size (needs bigger print bed)
- One piece Prusa MK3 bed size (should fit most heads but may be tight if glasses spacer is used)
- Two piece Prusa MK3 bez size. Full size but needs six M3 x 4mm countersunk screws and nuts.
I highly recommend printing in PETG. This is will allow great flexibility. PLA may be too brittle.
I also recommend bending slightly the end of the strap with heat gun this way its easier to install it into enclosure. Its fairly easy to do with use of sort of old pot with outer radius similar to the strap's curvature. The strap will conform to the shape when heated slightly with the heat gun.
Bending the printed strap arm with heatgun + old pot:
1. Use old pot with shape close to curvature of original strap. Heat evenly from the distance part highlighted in red below
2. After a while plastic will become soft and fall on the pot's surface like below:
3. Try not to move as plastic cools down. Done perfectly shaped strap
If you found it useful you can Buy me a Coffee!