Elder Wand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Project file for the Elder Wand from Harry Potter
- Ocena
- 4,778 / 5
- Polubienia
- 181
- Pobrania
- 1770
- Wydruki
- 19
- Wyświetlenia
- 6821
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Public Domain
Project file for the Elder Wand from Harry Potter
Printed vertically since I think the layerlines going around the model looks better than having it sliced along its length. I added support on the first layers manually, not for overhangs but for stability.
Vibrations
When printing the thinner part wobbles a bit when its half way done, so I reduced the print speed on the Prusa i3MK3S to 70%, later 60% to reduce the vibrations. I don't think it would tip over at 100% but the quality might suffer.
Layer Heigth
Since the Layers go “around” the model I don't think the 0.20 mm layer heigth looks bad. Sure, you can get improved detail with a lower heigth, but if you plan give it a layer of paint, most likely the paint will fill up the layer lines perfectly fine. The only place where you will see a difference is at the wide end and the engraved runes.
Other Wands
If you want other Wands, look up the models from the remix. Most models should work fine with these Settings.