HeeWing T1 Ranger DJI Air Unit mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
[edit] I have added a V2 which is lighter, but more importantly, allows a lot more breathability on the bottom, where…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 889
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
[edit] I have added a V2 which is lighter, but more importantly, allows a lot more breathability on the bottom, where the Air Unit gets hottest. I will be added a vent just below this spot (in the belly camera mount position) to bring fresh air in right onto the bottom of it. The vent is from someone else's design, so I need some time to chop it up and properly attribute credit.
I would rather use a Vista for this plane, but I don't own one, so I had to cram a full Air Unit in. This model has a slot through the bottom to allow for using a zip tie to hold it down.
It is mounted so that the antennas come up right behind the wing spar, which lets them exit right in a joint between the front and rear hatches -- a tiny bit of foam removed from the front hatch (basically removing a bit of round and making it a square corner) works perfectly.
I also use (and love) this antenna clip:
https://www.thingiverse.com/thing:4666842
I definitely isn't perfect, but does the job I need it to.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Filament:
Hatchbox PETG
Notes:
None
Category: R/C Vehicles