Torch display pillar for bigger little pumpkins
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Technically not a remix, but I wanted to light Davidson3d's pumpkins. Unsatisfied with an LED, I found a torch I…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 426
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Technically not a remix, but I wanted to light Davidson3d's pumpkins. Unsatisfied with an LED, I found a torch I bought from Maplin (see below) and then tried to work out a way to make it a pillar. With the torch ends, you can use this to uplight any object, they just press fit on the ends of the torch leaving the button and LED's accessible. You can even add a colour gel if you have one - 28-30mm diameter circle. The torch has a burn time over 24 hours with the supplied batteries
Here is the torch:
http://www.maplin.co.uk/p/9-led-rubber-torch-a78rn
Print Settings
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.2mm
Infill:
Doesn't Matter
Notes:
Print 2 stand parts and one pumpkin seat in black, and the Little Pumpkins in Dutch Orange at 200% size. Glue (yes, I said glue - didn't have time to build a screw option) a seat to a torch end and stick the pumpkin on.
If you use 100% infill the light will not get out and you won't see the infill... but the pumpkins will weigh a lot. Between 41 and 62 grams for the ones I printed out.
Category: Art Tools