Fridge Toys: Poet on a Stone
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mediaval style fridge magnets: Poet on a Stone.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 150
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ich saz ûf eime steine
und dahte bein mit beine:
dar ûf satzt ich den ellenbogen:
ich hete in mîne hant gesmogen
daz kinne und ein mîn wange.
dó dâhte ich mir vil ange,
wie man zer welte solte leben.
Walther von der Vogelweide, 1170 - 1230
75 x 121 x 4,3 mm
For me, using a 0,3 mm nozzle worked best. A 0,4 mm nozzle will do but you see the difference.
The model is meant for 2 color printing with a single extruder, you change the filament at a certain height. The base has 4 mm and then the drawing follows with 0,3 mm.
Slice it with a layer height of 0,3 mm.
and in the slicer insert a “Change filament” before the 15th layer (check the preview where the drawing on top starts!) and thus you can print it black on white or what colors you prefer.
The magnet goes into a hole on the back, it's made for 8mm diameter, 2mm height neodym magnets. The hole may need some sharpening of the edge after print and should hold the magnet tight without glue.
Print it with (tree-) support for the magnet-hole.
Going down with feed rate and temperature for the last layers may help avoiding stringing.