Octane stim (thumbdrive edition)

Octane's stim is back! now updated design, for an unnecessarily fancy thumbdrive with lights (because we luv lights)

Not interested in a thumbdrive stim? head over to this link for the first prop version: https://www.thingiverse.com/thing:4302470

NOTES!!!

bottom logo:

similar to "lock", but with a logo, because that's there ._.

for attaching "cap" when you take it off to plug the USB in

bottom:

this is where your main thumbdrive and LED is in, I used a sandisk thumbdrive (amazon link below) that's cracked open, the module is smol enough to fit in there.

wire up the LED and thumbdrive in parallel, LED requires a 100 ohm resistor

two rectangles sticking up, to align with "body"

body:

has two rectangle holes below to align with "bottom"

holes! small middle hole is for a 5mm diameter LED, small side hole is for the USB cable through the body

used a "neon" green acrylic tube 25mm OD (any ID is gud), cut a line at the small side hole to hide the cable

sand the acrylic inside, 200 grit max, for gud light diffusion

white and green LEDs are gud, but a blue LED makes the green acrylic really pop

lock:

similar to "bottom logo", but with a hole at the side for (you guessed it) the USB cable, align with the cut in the acrylic tubing and small side hole in "body"

NOTE: "lock" is designed to hold "cap" in place, so you have to do some manual alignment, with sufficient space for the cap to lock in

cap:

the USB cable will be stored in here, so umm, find a nice USB cable head

I personally used paint markers and spray paint for the colours, and then matte clear coat stuff

post a make! I'd love to see your iteration!

Sandisk thumbdrive: https://www.amazon.com/SanDisk-Cruzer-Blade-Flash-SDCZ50-032G/dp/B07RV2C63V/ref=sr_1_10?dchild=1&keywords=sandisk+flash+drive&qid=1622629609&sr=8-10

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

Standard Quality - 0.2

Infill:

Filament: unbranded stuff PLA black

Notes:

Category: Computer