Adjustable length stopper 2-15mm for automatic wire strippers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2-15mm continuously adjustable length stopper/gauge for automatic wire strippers (e.g. Irwin 2078300 and similar models)
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 75
- Wydruki
- 2
- Wyświetlenia
- 669
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Replaced the standard ¼"-¾" length stopper with a 2-15mm version to use on electronics rather than rough electrical wiring. Uses a M2 screw for continuous fine adjustment which also prevents slipping when stripping a lot of wires when making electrical harnesses.
1mm demarcations are on length stopper to assist with length adjustment.
Captive nut and heat set insert versions are provided, however only captive nut version has been tested. Slight angular freedom from the captive nut might be beneficial because the wire stripper jaw motion is not linear.
Additional hardware required:
- 1x 20mm (or longer) M2 socket cap screw
- 2x M2 nuts OR 2x M2 3mm heat set inserts
- 1x 20mm M3 socket cap or button head screw
Recommend slicing/printing with 0.4mm nozzle diameter, 0.2mm layer height, and no supports. Adjustment knob has 0.2mm layer covering the 2mm hole that needs to be punched through before installing screw.