1 / 8
KitchenAid Can Opener Replacement Handle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement handle for a KitchenAid can opener using M3 bolts for strength
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 45
- Wydruki
- 1
- Wyświetlenia
- 263
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
A potentially overengineered solution to a broken can opener handle. I didn't trust plastic alone to spin the metal piece and not deform over time, so I used 8 M3 bolts to keep this part strong.
Hardware Needed
- 6x 20mm M3 bolts. These Can be anywhere from 14mm-20mm, but 18mm or 20mm will work best.
- 2x 30mm M3 bolts. These can be anywhere from 20mm to 50mm, but 30mm ish will probably work best.
- I highly recommend using a hex bit in a drill or electric screwdriver to install the bolts and not doing it by hand. You can do it by hand, it will just take a while.
Assembly Instructions
- Slide the main piece onto the can opener before installing any bolts. Push down the spring before sliding it in.
- Install the 2x 30mm (ish) bolts on the inside of the main piece, parallel to the long side of the piece.
- Install the 4 bolts around the metal can opener piece on the inside
- Slide the Cover Piece into the end and install its 2 bolts.
- Open a can!