Marking Gauge Self Locking
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nothing else needed except a sharpened nail or pin.
- Ocena
- 4,5 / 5
- Polubienia
- 18
- Pobrania
- 63
- Wydruki
- 1
- Wyświetlenia
- 424
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
Firstly, I completely stole this idea from a Paul Sellers video on YT. He made this tool out of timber but I thought I'd see if it would work from a 3d printer and it works really well. Full credit for the idea goes to Paul, all I did was draw it up. Go check out his video to see how the locking mechanism works
Some tolerance has been built in but actual fitment will depend on your printer and settings. For speed, I printed mine at 0.3 layer height with a 0.6 line width on a 0.4 nozzle so not the greatest quality settings. The locking pin was a little tight but after a light sand and some paste wax it was good to go.
Clip the head off a nail, jam it in a drill and sharpen the end to a point. Glue that sucker in the hole at the end of the shaft and you're all set.
Optional: Push the locking pin cap to the end after it's all installed and working for an even cohesive look. Mine didn't need glue, they were a nice tight fit. YMMV.
Check out my other files for an adjustable mortise gauge using the same locking pin idea, as seen in the photo.