MR2 MWR cruise control extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I purchased the aftermarket cruise control from Monkeywrench Racing for my 2003 Toyota MR2 Spyder.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 429
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
I purchased the aftermarket cruise control from Monkeywrench Racing for my 2003 Toyota MR2 Spyder. This has been a very good unit so far (6 months) and a very welcome addition to this old car, BUT the battery-powered wireless control module mounted to the steering wheel is hard to reach unless you have orangutan thumbs. I designed this extender to slide onto the module mount and then you slide the module onto the extender, which brings everything closer to the front of the steering wheel where you can reach it. Does not interfere with the horn, etc. Note, I printed this in PETg and it fits loosely. I used a little duct tape inside the slider to make it fit tightly. You might want to modify it for your own use.
Print instructions
Category: Automotive Print Settings
Printer Brand: Prusa
Printer: i3 MK3
Rafts: No
Supports: Yes
Resolution: 0.15
Infill: 20%
Filament: eSun PETg black
Notes:
In it's current orientation, you can print with supports to the build plate only (no internal supports needed), and everything cleans up pretty easily. Just a little sanding where the supports contacted the object.
How I Designed This
Designed in sketchup