Charmander with glowing flame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of Patrickart's beautiful Charmander model - use it as a night light, as a showpiece, or give it to someone…
- Ocena
- 0 / 5
- Polubienia
- 57
- Pobrania
- 337
- Wydruki
- 1
- Wyświetlenia
- 2009
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution
A remix of Patrickart's beautiful Charmander model - use it as a night light, as a showpiece, or give it to someone you love!
Bill of materials
- All four 3D printed parts
- Three 10mm M3 self-tapping screws
- One 2x2032 coin cell battery holder
- LED fairy lights (about 1-2 metres) - see below for details
- One toggle switch (preferably with a 5mm thread)
- Some stranded copper wire
You'll also need some solder and a soldering iron. Heat shrink tubing is optional but I used it to insulate the contacts!
See below for detailed assembly instructions.
Print Settings
Printer Brand: Creality
Printer: CR-10
Rafts: Doesn't Matter
Supports: Yes, but only touching buildplate!
Resolution: 0.2
Filament: 3D AURA PLA, orange for body, transparent for flame
Post-Printing
Assembly
- Stuff the Flame (it should be printed in transparent PLA) with 1-2 metres of fairy lights that you can buy from your local dollar store or online.
- Glue the flame to Charmander's body, ensuring that the wires leading to the fairy lights pass through the hollow body into the hole underneath Charmander's tail.
- Glue Charmander onto the Base, ensuring that the hole underneath Charmander's tail lines up with the hole on the Base and the wires pass through neatly.
- Screw the toggle switch onto the side of the Base, solder the wires according to the picture shown to form a complete circuit and hot-glue everything in place. Remember to check the polarity!!
- Finally, use three 10mm M3 self-tapping screws to secure the Cover onto the Base.
