Clamp for heated soapstone bed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a clamp for mounting a 10mm thick soapstone plate to a delta printer. At minimum three pieces needed,…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a clamp for mounting a 10mm thick soapstone plate to a delta printer. At minimum three pieces needed, preferably six.
Why soapstone? The thermal properties of soapstone are quite ideal for this application, it stores heat and evens it out, so the build surface temperature stays stable and even across the surface. Also the surface of the stone is flat, deviations are negligible.
This was originally designed for a 10mm thick 285mm diameter pizza stone: http://www.hukka.fi/old/eng/?ID=1611&object=view&tuoteID=138.
Printing directly to the soapstone surface is possible and adhesion is good, if not even too good. Problem is that the pizza stone surface is a bit rough and you get some stone deposit stuck to the bottom of print.
As soapstone is rather easily tooled, I changed to 300x300x10mm shine polished soapstone floor tile and cut it round: http://www.tulikivi.fi/tuotteet/tk-281_tulikivi_blue.
Initially the adhesion to the shine polished soapstone was good and printed several prints without any additives. However, at some point the adhesion started getting worse, YMMV.
I don't know if this surface benefits of periodic cleaning and what cleaning agents should be used if any. When I started getting adhesion problems, I cleaned the surface with window cleaner and rinsed with water. Decided that some adhesion augmentation is needed, so I tried diluted PVA glue with mixed results and finally BuildTak/LokBuild.
I have built the stack like this (from top to bottom):
- Soapstone
- Silicone heating element
- Aluminum foil (to deflect heat to the right direction)
- 3-4mm cork insulation (IKEA Avskild)
- 2mm stainless steel plate (can be other material, just chose stainless steel as it's quite stiff at 2mm thick)
To augment the clamps holding the soapstone I've used oversized washers (20mm diameter for M6) under the mounting screws that go couple of mm over soapstone edge holding it down.
The clamps are designed to be used with M5x25 screws when using a 2mm steel plate under the clamps and mounting to 2020 profile. I've used DIN 562 square nuts in the profile, DIN 557 was too thick for my profile.
Print Settings
Printer:
Kossel XL
Rafts:
No
Supports:
No
Resolution:
0.05 - 0,3
Infill:
25% at minimum
Notes:
The bottom of the clamp is 5.15mm thick in design, so only 50um layer height would produce that height. However, the final thickness of the clamp is irrelevant as all are of the same thickess if printed at the same time.
Drill out the hexagonal holes to 5.5mm diameter.
Category: 3D Printer Parts