XT-60 Female Flat Panel Enclosure Mount for Amass Connectors IMPROVED
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed "Amass XT60 enclosure mount" to fit better with the following improvements Made the hole for the front mount…
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 346
- Wydruki
- 1
- Wyświetlenia
- 1522
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I remixed "Amass XT60 enclosure mount" to fit better with the following improvements
- Made the hole for the front mount and front half of the connector 0.5mm larger in each dimension for easier fitting of male piece when connecting
- First 3mm of connector is larger so the Amass female connector fits in far enough that the male end can fully press in
- Doubled the height of the two side hex nut holders and made them a little smaller so the nuts friction fit in perfectly
One of the files is a .3mf file I exported from PrusaSlicer, you can just load that in and tweak settings as you want. I printed with a "support enforcer" under the overhang but nowhere else, so that support only prints there. I don't bother removing the supports because it's just 2 layers of it and screwing in the nut breaks free of it easily enough.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
30
Category: Robotics