Angle Bracket for COB LED Strip 6015
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stepless angle bracket for mounting 6015 COB LED strip. This is a component of an ongoing project, for providing…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 562
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
A stepless angle bracket for mounting 6015 COB LED strip.
This is a component of an ongoing project, for providing adjustable LED light sources.
However, I think this can be practical in a variety of cases, the two M2 holes in the base can be used to fasten it to aluminum profiles for a 3D printer.
If M2 screws are not available, two pieces of 1.75mm filament can also be used as the shaft, and attach the LED and bracket with VHB double-sided tape.
When using layer height of 0.1, the M2 nut can fully slide into the groove. When using layer height of 0.2 I have to heat set the nut with a soldering iron to help it sink into the groove.
Print Settings
Printer:
Voron 0.1
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%~30%
Filament:
PolyMaker PolyLite ABS
White
Category: 3D Printer Parts