5"x5" Model aircraft propeller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
5 inch diameter, 5 inch pitch propeller designed using Javaprop. Has a 5mm hub bore.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 222
- Wydruki
- 1
- Wyświetlenia
- 713
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I designed this for use on my flying wing with a 2300 kV BR2204 motor running on 2S LiPo (7.4V). It uses NACA 16-series airfoils, and draws about 50W with this setup.
For best results, print it upside down (leading edges touching the build plate) and use a high density support interface to get the best possible finish on the overhung side. Carbon fiber Nylon (the pictured prop was printed using eSun ePA-CF) or PETG both work on 2S, however the added strength of the nylon might be needed if you are using a higher kV motor or higher cell count.
Post processing: balance the propeller and sand to smooth the layer lines. You might also paint it with resin before balancing to improve smoothness further.