FT Explorer landing gear and motor mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nose wheel mount, main gear mount, and motor mounts for use on the FliteTest Explorer RC airplane kit print nose wheel…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 708
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Nose wheel mount, main gear mount, and motor mounts for use on the
FliteTest Explorer RC airplane kit
print nose wheel mount with the sloped face down so that no supports are required.
The control horn mounts with the control arm down so no support required.
Use 3/32 or 3mm piano wire for both nose and main gear.
The Main gear wire should be made in two pieces with a vertical bar pointing up on the inside of each so that both slot into the hole in the main gear plate. height and width of the main gear is up to builder.
Nose wheel plate should be glued behind the first velcro slot with a pushrod going back to the rudder servo.
use a M3 screw to hold the nose wheel in place
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: eSun PLA Red
Category: R/C Vehicles