HXT900 SG90 flush mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flush mount I use for my FliteTest airplanes. The servo slides in very tight. the cover just holds in in place. It…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 267
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Flush mount I use for my FliteTest airplanes. The servo slides in very tight. the cover just holds in in place.
It fits HXT900 and SG90 servos. MG90's should also fit but have not tested.
The V1 I have used twice but the cover does not sit flush when screwed down so I created V2.
V2 has a slightly thicker top plate so that the cover sits flush. I also streamlined the control horn protector. I also opened up the gaps for the servo wire because I had to cut the V1's for use in the Sea Duck. This new design allows the wire to be fed directly out the bottom or the side.
V2 has not yet been tested, but it is based on V1 which works.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
Yes
Resolution:
0.16
Infill:
25%
Filament: eSun PLA+ Black
Category: R/C Vehicles