Artillery SW-X1 fan shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a repost of my fan shroud.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 899
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a repost of my fan shroud.
I used PETG to print this shroud and haven't had an issue so far with sagging, but I also have a heat block sock on my machine. With how close this is to the heat block it may be best to print this in ABS.
I would suggest to use no less than 3 perimeters when printing to strengthen the screw hole.
I did use a small drop of glue to hold up the non screw side of the shroud to the fan.
NOTE; if using Steve Wagg's BL Touch mount, his back plate interferes with the mounting of this shroud. I was able to trim his back plate with a knife to get them to work together.
Print instructions
Category: 3D Printer Parts Print Settings
Printer: Artillery Sidewinder
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: .2
Infill: 20
Filament: Any PETG Any