SW-X1 Fan Shroud V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New design of the Artillery Sidewinder X1 fan shroud.
- Ocena
- 4 / 5
- Polubienia
- 10
- Pobrania
- 240
- Wydruki
- 1
- Wyświetlenia
- 1900
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
New design of the Artillery Sidewinder X1 fan shroud. It was designed off a Prusa MK3s Bondtech BMG fan shroud with Joel Nicklasson's fan bracket, but designed to mount to the original fan mounting location.
This shroud sits close to the heat block and would be best printed with a higher temp material such as ABS
It is designed to print with the shroud bottom to the build plate.
It has been printable for me with just the one support as shown in the picture. Depending on your printer/settings more maybe necessary.
This is designed to hold the stock parts fan with the intake in the upward direction, but the wires for the stock fan will be too short and will need extended.
Extend wiring or new fan with longer wire
1) 3mm x 6mm Socket cap screws
1) 3mm x 8mm Socket cap screws
2) 3mm x 28mm Socket cap screws
2) 3mm nylok nuts
Print instructions
Category: 3D Printer Parts Print Settings
Printer: Sidewinder X1
Rafts: No
Supports: Yes
Resolution: 0.2mm
Infill: 25%
Filament: Amazon Basics ABS Black