1 / 6
Bicycle Aerobar Spacer compatible with Profile Design
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacers to lift up your aerobar and save your back.
- Ocena
- 4,714 / 5
- Polubienia
- 54
- Pobrania
- 834
- Wydruki
- 6
- Wyświetlenia
- 6091
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (10)Wydruki i komentarze (Wydruki: 6) (Komentarze: 9)Remiksy (0)Kolekcje (69)Powiązane
Lift up your aerobar and save your back!
- Should be compatible with Profile Design aerobars.
- Tested with Profile Design Legacy II.
- Handlebar diameter: 31,8mm
Print and use at your own risk!
Additional parts required
You need 4 x M6 screws to replace the original screws with longer ones.
The original screw of the Profile Design Legacy II was 15mm. To figure out the required length of the screws, you need to add 15mm to the spacer height:
| Spacer height (mm) | Screw length (mm) |
| 5 | 20 |
| 10 | 25 |
| 15 | 30 |
| 20 | 35 |
| 30 | 45 |
| 40 | 55 |
| 50 | 65 |
| 60 | 75 |
| 70 | 85 |
Additionally, you might need to use some washers if the screw length doesn't match perfectly.
Print settings
- nozzle size: 0.4mm
- layer height: 0.2mm
- material: PETG (for increased resistance against heat from the sun)
- infill: 80%
- supports: no (tested on an Ender 3 V2)
Tested
- 40mm version
- printed with the above settings
- with a Profile Design Legacy II
- on a 300km mostly gravel track
No issues. Spacers still look in very good shape.