BIQU H2 System for CR-10 V2 or V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
**** Check out this one also: https://www.printables.com/model/223465-biqu- (I think it is better for the CR10 V2/V3 as…
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 94
- Wydruki
- 1
- Wyświetlenia
- 1326
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
**** Check out this one also: BIQU H2 Fan duct by FHOGPHIL | Download free STL model | Printables.com (I think it is better for the CR10 V2/V3 as less chance for interference on a tall print. It is what is on my printer now)
This one was designed to have the shorter sided of the heat block to the front and back. If you want the longer sides front and back, check out this remix: https://www.thingiverse.com/thing:4864920
Complete system to mount a BIQU H2 to a Crealty CR-10 V2 or V3.
Route heater and thermistor wire between mount and plate. Heater wire should exit heat block on the left side as you look at the printer.
Will require M3 bolts and nuts.
Attach mount to H2, assembly to printer, duct to H2 and finally the fan.
My BTT Smart filament sensor mount is included.
Recommend printing mount solid. (100% infill or 999 bottom layers however you wish).
The fan duct was designed for a 0.4 nozzle and .12 layers. I have reports that .2 layers have worked.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
.12mm
Infill:
100
Filament: Any PETG/PLA Any
Notes:
I used PETG for duct and CF PLA for the rest.
Isolate supports to just the area where the duct mounts to the H2.
How I Designed This
Modeling
Used SHAPR3D on IPAD.
Category: 3D Printer Parts