HPI RS4 / Nitro Star G3.0 Carb Throttle Linkage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement Throttle Linkage for a HPI RS4s Nitro Star G3.0 engine. I recommend printing this edge down with supports…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 620
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Replacement Throttle Linkage for a HPI RS4s Nitro Star G3.0 engine. I recommend printing this edge down with supports as shown to avoid layer lines going horizontally across the neck of the part.
WARNING THIS PART MIGHT RANDOMLY FAIL!!!
Recommended only as an emergency/short term fix.
This prints only been left online for those who already downloaded it, for people to check/reference it for sizes & to display the warning above
EDITS
09/04/20 PLA has worked fine for me for the last 2 months. ---but it eventually failed!!
28/10/2022 My original print from the photo here suddenly broke with zero strength after two years, just glad it burst while the car was on the work bench. I'd highly recommend making a linkage from a piece of brass sheet like i've now done if you're unable to buy an original replacement online. Don't rely on this printed part not randomly failing on you one day.
Category: R/C Vehicles