Motor mount & skis for foamboard RC plane: Dual Prop Sport
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d printable parts to aid in a lightweight multi prop fixed wing RC plane.
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 175
- Wydruki
- 0
- Wyświetlenia
- 2047
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
3d printable parts to aid in a lightweight multi prop fixed wing RC plane. Wing and fuselage may be built using common foam-board technique (see Experimental Airlines in YouTube, or wait for my more details plans to come out after a bit more testing).
PLA, 15-20% infill, no supports (except for skis which need supports)
Compatibility (as tested):
Wing/airfoil: 6-8" cord, 20mm thick
Motors: X2206 1500kv Sunnysky (18g), or similar mounting pattern (not typical)
ESC: 21mm max width, (12A velotech, 1A BEC, or similar - narrower than most)
Prop: Turnigy Slowfly Propeller 7x3.8 Black (CW & CCW)
Plane as shown built with 40" wingspan using dollar tree foam board and model plane foamboard (MPF) used for the fuselage and stabilizers.
Ski components can be epoxied together, and holes and landing gear legs are intended to be held in place with the dowel used to hold the wing in place with rubber bands.
See my website RCsean.com for more info, prototype videos, etc.
Print instructions
PLA, PET, etc, 15-20% infill, no supports (except for skis which need supports)