1 / 1
Merged Retraction Test in detail ( 2mm to 3.4mm) — zdjęcie 1

Merged Retraction Test in detail ( 2mm to 3.4mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Retraction test provided by FoxyLad is very useful. So I merged some parts for fine tune for print at once.

Ocena
0 / 5
Polubienia
10
Pobrania
59
Wydruki
0
Wyświetlenia
569
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Public Domain

I tried tuning retraction setting for TPU.  Each test is just in 8 minutes, but I needed to remove printed part and print part in new setting. I hope to start print for several setting at once, so I merged some settings. Original design is done by FoxyLad. This is the model for fine tune from 2mm to 3.4mm of retraction length.

From the front, the settings are as follows,

Retraction: 2.0mm, 2.2mm, 2.4mm, 2.6mm, 2.8mm, 3.0mm, 3.2mm and 3.4mm

Retraction speed: 70mm/s

temperature: 200 degree to 235 degree in 5 degree step.

230 degree for Polymaker TPU95, 225 degree for Reprapper TPU

If you’d like to tune some parameters, please refer the 3mf file.

Tagi