Anycubic Mega S TMC 2208+ Dual Fan Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Overhead dual fan bracket for Mega S boards with tall stepper driver heat sinks. Twin 40x10 fans in original position.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 669
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I could never find a fan bracket that fit fans in the original overhead position for tall heat sinks on the 2208 and up drivers. They seemed to be all from the side or require replacing a chunk of the bottom plate with another printed grille. There is a little less than a millimeter to spare when mounting 10mm fans over the top, so the challenge is obvious. I have designed a bracket that allows two 40 x 10 fans over top without cutting the bottom plate.
This works with my specific configuration, using two Noctua 40 x 10 12V fans, BTT TMC2208 V1.2, Trigorilla 1.1 board. There is only a fraction of a millimeter to spare, so if you install using this bracket, attach the bottom plate slowly to avoid damaging your fans.
Requires 15 mm M3 socket head screws and M3 nuts to mount fans to the bracket, and 20 mm M3 screws to mount the bracket to the board.
I may opt to drill a couple clean holes in the plate, depending on available air intake with their present position.