Horizontal Spool Holder using BBs as rollers.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Horizontal spool holder. Why? Because I have more bbs laying around than 608 bearings and the bearings I have are junk…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 360
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Horizontal spool holder. Why?
Because I have more bbs laying around than 608 bearings and the bearings I have are junk this rolls way easier. The extruder has a very easy time pulling filament from this design almost effortless. It's kind of like a lazy susan for filament.
I do recommend some tape on the bottom just in case, as the spool gets lighter it may want to slide more than spin.
Note: you may want to scale the nut by 2% in the X and Y direction only, makes it thread a bit easier.
there are 3 parts required for the design.
Category: 3D Printing