X-Gantry Stepper Cover for Cable Chain (Ender 3/Pro) with internal cable protection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a cover for the X-gantry in an Ender 3 with special protective cable guidance.
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 380
- Wydruki
- 1
- Wyświetlenia
- 1775
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
After I upgraded my Ender 3 Pro extruder to a Micro Swiss Direct Drive, cable management became an issue. Thus, I decided to embed all cables from the extruder into a cable chain and lead them to the rear-box, where the controller board and a RPi are enclosed.
The tricky part was to divert the cable chain nicely to the back. So I remodeled a x-gantry cover with chain adapters and added a half cylinder on the inside to protect the cables from being worn from the belt and pulley of the x-stepper.
The adapters fit the well-known cable chain designed by @jonnywhiskey.
This cover can also be used with my cable holder I designed and remodelled for a Micro Swiss Direct Drive
If you like my stuff, then please leave a 👍 and post a make. Thanks!