Unicorn Wand

The horn is 210mm high, so you will need a taller printer. It prints well in PLA or PETG. You should probably switch off the "Fill Gaps" setting on your print. While the majority of this model is 2 walls thick, sometimes in corners it can want to add a bit and it will print faster and use less filament without this. There is a sacrificial hole covering at the top and this should be removed.

There is a hilt option for your wand, depending on whether you want to swish, or stab.

Print out a handle, hilt and horn and screw the hilt over, then attach the horn and you're good.

You can add magic sprinkles (glitter) into the handle as well.

Handles and stands

If you need to change the sprinkles you can pre-load some handles and store them with lids. There is even a stand that will let you store a wand and spare handle ready to go. or handles, to 2 wands… There is even a 6-handle option as well. The base screws to the pole using an M3 screw. If you do this you should probably also get some rubber feet to get all grippy and raise the base off the tabletop, otherwise, glue will work.

The top screws to the pole with the supplied bolt.