Improved IR filter mount for point and shoot camera

Print orientation:

Recommended settings:

1. Print using 0,3mm line width and 0,1mm layer height.
2. Use brim and supports for “filter” part.

Full process instruction:

1. Convert your camera to full spectrum https://youtu.be/XFOHWaL7XsM 
2. After printing parts screw them few times until they start screwing smoothly
3. Prepare your filters: I used overexposed film negatives, they pass infrared but block most of visible light, cut them to correct size (so they fit in “body” part)
4. Mount “body” to your lens. Extend the lens → apply hot glue onto “body” → stick “body” to the lens → retract the lens → hold until the glue has cooled down.  Double sided tape also works well and you can create spares if parts come off.

Warning:

During unscrewing “filter” you may unscrew whole lens end cap that protects lens cover mechanism. You can screw it back without problem but be careful not to destroy small plastic tabs that holds it in place.