Darth Vader Fun split for optimal printing with minimal supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Darth Vader Fun by Val, split for printing with minimal supports.
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 425
- Wydruki
- 4
- Wyświetlenia
- 1853
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution
This is a version of Darth Vader Fun by Val, split just below the “chin” to provide optimal placement on the print bed with minimal supports. When I first printed Fun Vader I opted to print him standing on his head with supports as it appeared that printing him feet down would require a lot more supports, but that led to a rough area on the top of the helmet where it interfaced to the support material. The 3mf file included here has minimal supports under the helmet and some small brims where the helmet touches the bed. All are easy to remove. There are rectangular alignment sockets on the surfaces where the model was split and a small alignment peg to assist with alignment prior to gluing.
Instructions:
- Print the objects in the 3mf file. You should be good to go for supports but feel free to make adjustments if you'd like.
- Remove the visible supports and brims under the chin and helmet.
- Insert the alignment peg into one of the sockets. Test fit the pieces before gluing.
- Apply CA glue to one surface. Don't use too much, you know the drill.
- Press the pieces together and align. You have a few seconds of working time before the CA sets. Alignment will be very easy. Once the pieces are aligned, squeeze them tight for about 20 seconds.