3 Powerbank Charging Station
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hold 3 large-ish powerbanks for charging.
- Ocena
- 4,75 / 5
- Polubienia
- 11
- Pobrania
- 73
- Wydruki
- 4
- Wyświetlenia
- 582
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My family constantly needs to charge their devices on the go. My 7-port USB charger gets a daily workout charging all of them!
Before this, I just kind of stacked them in a pile next to the charging station. I thought that was unsightly, so I made this. My family can just put a powerbank into this holder, plug up a cable, and not worry about knocking over a pile of powerbanks. It should accommodate any power bank up to 80mm wide and 25mm thick. I tried to make the holders tall enough to accommodate long powerbanks that might tip over if stored vertically.
I printed it in Eryone Red PLA, .28mm layer height, 3 perimeters, 5% infill. Not a lot of infill is needed-- walls are most important. No support is needed. PETG might be a better option. Share your makes!