Shower Razor Holder - Suction Cup
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New shower, needed a spot to hang my razor (Razor Model/Faster than sound x 3)
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 127
- Wydruki
- 0
- Wyświetlenia
- 454
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Yep, I needed a spot to hang my shower razor. Do I have a ledge I could use? Why yes, yes I do - but what fun would that be.
Anyway, I knocked out this rough prototype, possible changes to come. I'll reprint in black to match the other accessories but it works and it works well. I chose to keep the blades facing out because I wanted the slop of the holder to angle (30) outwards to keep the razor from falling out which happened to coincide with the angle of the razor with the blades out.
The suction cup is something I had laying around so I sized the mount holes for that one (3.25mm/15.5mm).
I printed this using my Prusa i3 using generic PLA with a resolution of .15 On the final version I will most likely switch over to ABS with a quick Acetone vapor bath. I may also beef up the dimensions a bit for pure ascetics. I had zero issues printing this on it's flat back, no rafts nor supports were needed.
Like my design, how about a cup of coffee?
